Repairs
Repair & Maintenance
Sealing out the weather is part of repair, not an afterthought. Along with the mechanical work, we replace bottom rubber, perimeter weatherstrip and worn thresholds so the garage stays drier and warmer.
Which one do I need?
- During the power outage you pulled the red cord and tried to lift the door by hand.Garage Door Safety Inspection
- Halfway up, the door shudders.Garage Door Tune-Up
- One side of the door hangs a hand's width lower than the other.Off-Track Garage Door Reset
- Rust has crept along the bottom edge of the lowest section.Garage Door Panel Replacement
- The strip under the door has gone as hard as a hose left out for ten summers.Garage Door Bottom Seal Replacement
- Every time the door closes there is a rubbing squeal along one side, and the flexible fin has folded under itself and torn.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.
Garage Door Safety Inspection
Springs, cables and drums, looked at and left alone
The counterbalance gets a careful look and nothing more during the inspection. On a torsion door the technician checks the spring coil for a gap, rust or a stretched section, confirms the cone set screws and centre bearing look sound, and follows each cable from the drum to the bottom bracket looking for broken wires, a rust bloom near the loop or a slack side. The drum wrap is checked for a single neat layer.
On an extension door the springs, pulleys and containment cables are examined the same way. Any adjustment to these parts is a separate, planned job matched to that system, torsion tension controlled with winding bars rather than simply released; the inspection records their condition.